10
Connect the steamer to the mains socket, the display will show the Clock
mode. When Clock mode is lit, it means the unit is switched on but not in
Steam mode.
Setting the Current Time
1. Press and release the PROG button and the 0/I button at the same time,
the buzzer will sound.
2. To set the time, press the -/+ button. Each press (+) increases the time
by 10 minutes. Each press (-) decreases the time by 1 minute.
3. When the time is correct, press the PROG button.
Immediate Steaming
1. In Clock mode, press and release the 0/I button, the display will show
“45“.
2. Set the steaming duration by pressing the -/+ button. Each press
increases or decreases the cooking duration by 5 minutes. The
maximum steam duration is 90 minutes.
3. After setting the steaming duration, wait for about 2 seconds, the
buzzer will sound. The indicator light will illuminate red and steaming
will begin.
4. During steaming, you can press the -/+ button to adjust the steaming
duration.
5. At the end of the steaming cycle, the indicator will change from red to
green. You can also stop steaming by pressing the 0/I button.
6. When steaming has nished, the unit will automatically enter Holding
mode.
Delay Start Steaming
1. In Clock mode, press and release the PROG button, the display will show a
ashing “00:00”.
2. Set the extent of delay start duration by pressing the -/+ button. Each
press increases or decreases the extent of delay by 10 minutes.
3. Press the PROG button to conrm, the display will show “45”. Then press
the -/+ button to adjust the steaming duration.
4. Press the PROG button again, the display will show the time and PROG,
conrming the steamer has started the countdown for delay start
steaming.
Operation
L90SSS11_IB_RC_151126_grace.indd 10 26/11/15 10:26 am
To Next Page
Loading...
Need help?
General