7
Using the Touch Controls
• The controls respond to touch, so you don’t need to apply any pressure.
• Use the ball of your finger.
• You will hear an audible tone each time a touch is registered.
• Make sure the controls are always clean, dry, and that there is no object (e.g. an utensil or a cloth) covering
them. Even a thin film of water may make the controls difficult to operate.
3. Select a heat setting by touching the or controls.
The unit will start from setting 5.
If you don’t choose a heat setting within 1 minute, the
ceramic hob will automatically switch back to standby
mode. You will need to start again at step 1.
You can modify the heat setting at any time during cooking.
Using Your Ceramic Hob
To Start Cooking
1. Touch the ON/OFF control.
After turning on, you will hear an available tone. All the
indicators light up for 1 minute then go out, indicating that
the ceramic hob has entered standby mode.
2. Place a suitable pan on the cooking zone that you wish to
use.
Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry.
Do not place hot pans over the control panel
as this may cause damage.
LCHOBTC10_IB_110506.indd 7 5/6/11 1:47 PM
To Next Page
Loading...
