• Do not lift the drain hose higher than 10 cm
from the table top, otherwise the unit may not
be able to expel the waste water properly.
6. Make sure your plumbing is suitable for use with the
dishwasher. If in doubt contact a qualied plumber.
This unit MUST BE connected to COLD WATER
MAINS using the new water inlet hose. OLD HOSE
SETS MUST NOT BE RE-USED. The water pressure
from the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
• Connect one end of the safety water supply hose
to your dishwasher, and then connect the other
end of the hose to your water mains. Please
ensure the black rubber seal is in place.
• After connecting the hose, turn on your water
Connect the dishwasher to the mains socket.
• Do not bend your drain hose.
• Secure the water drain hose to the waste pipe to
avoid it coming o during the washing process.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
water supply hose
max.
10cm
You may use a Y-Adaptor (not included)
for an additional water feed for another
appliance, for example a washing machine.
This is only applicable for cold water mains. A
Y-Adaptor is available from most DIY stores.
About the Safety Supply Hose
The safety supply hose consists of
the double walls. The hose’s system
guarantees its intervention by blocking
the ow of water in case of the supply
hose breaking and when the air space
between the supply hose itself and the
outer corrugated hose is full of water.
• The waste pipe must only be connected
to the foul drains and not the surface
water drainage system.
• The water drain hose should be placed
between 40 cm and 100 cm from the
oor level and must not be extended,
otherwise the unit may not be able to
expel the waste water properly.
• Please close the hydrant after using.
Please close the hydrant after use.
To Next Page
Loading...
Need help?
General
