10
4. Position the unit next to a water tap and a drain.
5. Ensure the water inlet and drain hoses are not kinked
or squashed. The unit must not stand on the mains
cable.
6. Make sure your plumbing is suitable for use with the
dishwasher. If in doubt contact a qualied plumber.
This unit MUST BE connected to COLD WATER MAINS
using the new water inlet hose. OLD HOSE SETS
MUST NOT BE RE-USED. The water pressure from the
water mains needs to be at a minimum of 0.04 MPa
and a maximum of 1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect the
other end of the hose to your water mains (see
diagram).
water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
safety supply hose
You may use a Y-Adaptor (not included) for an
additional water feed for another appliance,
for example a washing machine. This is only
applicable for cold water mains. A Y-Adaptor
is available from most DIY stores.
About the Safety Supply Hose
The safety supply hose consists of
the double walls. The hose’s system
guarantees its intervention by blocking
the ow of water in case of the supply
hose breaking and when the air space
between the supply hose itself and the
outer corrugated hose is full of water.
LDWTT20N_IB_5L_RC_Final221111.indb 10LDWTT20N_IB_5L_RC_Final221111.indb 10 11/11/2022 3:43 PM11/11/2022 3:43 PM
To Next Page
