Before resynchronizing, ensure the cause of the problem has been addressed. For example, remove all
obstructions so that the entertainment devices can receive the infrared commands from the Harmony
remote. Note: If your devices are no longer responding consistently to your Harmony remote, but were
doing so before, you may need to replace the remote's batteries.
To resynchronize:
1. Press the Help button. The Harmony remote will resend the appropriate commands to your
entertainment devices and then ask you a series of questions such as "Is the Television On?"
and "Is the Stereo Receiver set to the DVD input?"
2. Answer the questions on your LCD by selecting Yes or No. If you answer "No" to any question
the Harmony remote will resend the necessary command and ask you the same question again.
When you are done, the Harmony remote will be "in sync" with your devices again.
Using Sound and Picture Modes in an Activity
Once you have selected an activity, the functionality of each button on your Harmony remote is
automatically configured for that activity. Additionally, the Custom Buttons and LCD will give you
access to other commands for that activity, which cannot be set to the standard buttons. This is known
as the Activity mode.
Within each activity you can change how the Harmony remote behaves by switching into one of 3
alternative modes:
Sound Mode
Sound mode focuses on controlling the sound features of the relevant device you have chosen to
control your sound (e.g. Stereo Receiver). When you are in any activity, press the SOUND button to
switch to this mode. Once in Sound mode, the Harmony remote will only control sound features.
For example, if you have chosen your Stereo Receiver to control the sound in your Watch a DVD
Activity, the Sound mode will change the Harmony remote buttons to control the Stereo Receiver as
completely as possible. In the LCD you will see commands such as Surround Field or Bass+.
Press the SOUND button or appropriate Activity button to return to Activity mode.
Picture Mode
Picture mode focuses on controlling the picture features of the device you have chosen to view your
pictures (e.g. TV or Projector).
When you are in any activity, press the PICTURE button to switch into this mode. Once in Picture
mode, the Harmony remote will only control picture features.
For example, if you have chosen your Projector to display the video in your Watch a DVD Activity,
the Picture mode will change the Harmony remote buttons to control the Projector as completely as
possible. In the LCD you will see commands such as Aspect or Picture Adjust.
To Next Page
Loading...
Need help?
General
