LogTag TRIX-8 V2 - Page 3

LogTag TRIX-8 V2 Work Instruction Manual Revision 10.17 Page 3/44
10.06
25/3/10
SS
Updated Appendix 1,2 and 3. Revised BOM changing 3.3K Res to 0603, changing PCB to
rev 160320.
10.07
1/7/20
SS
Updated Appendix1,2 and 3 Revised BOM changing 12pF loading capacitor to 15pF.
10.08
3/07/20
AC
Updated process in section 1.10 “Apply RTV and conformal coat” emphasizing the proper
conformal coating of the tantalum capacitors and conformal coat over RTV’d crystal, C3, C4,
and top of U1.
Updated RTV cure time to 8hrs and conformal cure time to 3 hrs.
Updated images on APPENDIX 1, APPENDIX 2, APPENDIX 5 and APPENDIX 6 to rev
160320 PCB.
Updated C3 and C4 from 12pF to 15pF in BOM with part no. 261-11551-44-71 CAP SMD
15pF +/-5% NPO 50V 0402
Updated production software images revision to 2.8r27
Updated WIM to revision no to 10.08
10.09
15/07/20
AC
Updated production software installer "LT_PM3-setup_27r91.exe in section 1.5
Updated production software to 2.8r28.
Updated APPENDIX 4: Firmware programming specification using fw 1.48
10.10
20/07/20
AC
Updated production software installer "LT_PM3-setup_27r92.exe in section 1.5
Updated production software to 2.8r29.
Updated APPENDIX 4: Firmware programming specification using fw 1.49
10.11
220121
MJ
Changing to Abracon xtal:
Updated PCB to 011220, Updated schematic, BOM and images.
Updated PCB cleaning area and conformal coating area.
10.12
21/07/21
MJ
Updated BOM, Switch to using CITIZEN SMD xtal, ABRACON is alternate
10.13
16/9/21
MJ
Remove BOM from WIM, now separate spreadsheet.
10.14
28/9/21
MJ
Updated to include TRIX-16, BOM is separate spreadsheet
10.15
17/11/21
AC
Changed shortcut name from “Check and Final test” to “Trix Check and Final test (USB)”
10.16
28/07/22
AC
Added “Note #5” in page 37/44 to re-Customise unit if LED flash after Customisation.
10.17
20/06/23
AC
Updated “2.11 Temperature cycling test” from 3 cycles to 2