LogTag UTRIX Work Instruction Manual Revision 1.07 MP Release Page 36/52
2.11 Perform ‘USB LogTag Check - Final Test (USB)’
Reason for test stage:
To verify assembled LogTag product function and setup the default profile.
This is a specific test for all USB HID products.
Equipment required:
• PC installed with Win 7 and the USB LogTag Check - Final Test (USB) test software package.
Installation version 2.8 build 3 or later.
• PC must have at least two USB Ports available.
• LTI/USB production interface with integrated temperature sensor.
• USB extender base (USB-A male to USB-A female).
To Next Page
Loading...
