LogTag UTRIX Work Instruction Manual Revision 1.07 MP Release Page 40/52
Failures & Corrective action
If a test fails then a display similar to below will open describing failure.
If the product will not pass the test – remove it from the interface and click ABORT.
Place in separate marked container for service check. Rejected products must be clearly identified and
kept apart from accepted products
NOTE:
ALWAYS use the Close button to exit program
DO NOT reset or switch off computer while it is running any test otherwise production log files may
become corrupted!!
Product that has passed Check Final is not in a correct state for shipping – all product must pass
through the customisation phase before shipping. Product direct shipped from Check-Final without
customisation will not be able to be used by end users.
To Next Page
Loading...
