Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 15
3. Open the locking hooks from both sides of the bed. However, do not
remove them yet. Plug in the power cord.
Image 17. Locking hook
4. Make sure that the cord of the hand-held controller is not trapped
between the structures.
5. Press the back section down button (see section 6.7) until the sleeping
surface is in the operating position.
Image 18. Adjusting the sleeping surface into the operating position
6. When the sleeping surface is in the operating position, pull out the back
section locking hooks from both sides. Move the locking hooks to lock the
To Next Page
Loading...
