Lojer Modux - Biannual Maintenance Checks; Annual Maintenance and Inspection

Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 38
Any kind of modification of this bed without authorisation of
manufacturer is prohibited.
9.1 Biannual procedures
Biannual maintenance procedures are mainly routine checks carried out by
the user. At least every six months, check that the following parts and features
are working properly:
 power cord and its connection to the bed
 motor wiring
 hand-held controller and its cable
 side rails (functional testing)
 brakes (check that the brakes hold)
9.2 Annual procedures
For annual maintenance, use the inspection instructions found in section 11.
Copy the form and record any performed maintenance work if you do not have
a recording system of your own. Perform an annual three-part inspection,
maintenance and testing procedure as follows.
Inspect the condition of the motors, brakes, and wheels. Take special
care and carry out more inspections if there is load placed on the bed, if
the bed is constantly used at maximum load (SWL) or, for example, the
platform is raised more than 3,000 times per year.
9.3 Visual inspection
Check for any damage; fractures, deformations, signs of unusual wear,
possible looseness of joints and fastenings, etc. Also check the attachment
points (mounting points for the motors and mechanisms) in the following
sections:
 sleeping surfaces and support structures
 in the Modux model, pay special attention to the middle section of the
upper frame of the bed (bed folding section), its joints and its attachments
in general
 upper frame structures, strut bar attachment points, strut bars
 structures for lifting mechanisms
 mounting points for accessories
 lifting pole and IV pole sleeves and attachments
 rails and headboards
 accessories
Check the condition of the bed’s electrical devices and their wiring: fractures,
fasteners and cable clamps, the condition of the plug, signs of wear or
abrasion on the cords, and the tightness of the screw attachments in the
following locations:
 control unit
 motor wiring
 cord fastenings
 power cord