LONCIN LX700U User Manual

95
a. Spark plug gap
Installation
1. Clean the surface of the spark plug gasket
and its mating surface, and then wipe off
any grime from the spark plug threads.
2. Install the spark plug and tighten it to the
specified torque. If a torque wrench is not
available when you are installing the
spark plug, a good estimate of the correct
torque is one-quarter to one-half turn
past finger tight. Have the spark plug
tightened to the specified torque as soon
as possible.
3. Install the spark plug cap.
4. Reinstall the console.
Spark plug gap:
0.8-0.9mm(0.031-0.035in)
Tightening torque:
Spark plug:
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
a

LONCIN LX700U Specifications

General

Brand	LONCIN
Model	LX700U
Category	Utility Vehicle
Language	English