To charge a VRLA (Valve Regulated Lead Acid)
battery, a special (constant-voltage) battery
charger is required. Using a conventional bat-
tery charger will damage the battery.
To store the battery
● If the vehicle will not be used for more
than one month, remove the battery,
fully charge it, and then place it in a cool,
dry place.
● If the battery will be stored for more than
two months, check it at least once a
month and fully charge it if necessary.
Be sure the battery is fully charged.
1. Place the battery in its compartment.
2. Connect the positive battery lead first,
then the negative battery lead by in-
stalling their bolt.
When in-
stalling the battery, the main switch
must be off, and the positive lead must
be connected before the negative lead.
3. Hook the battery band.
4. Close the hood.
To Next Page
Loading...
Need help?
General
