Set System Time/Date for Staff Pagers
The time on Alphanumeric pagers may be reset each time batteries are replaced. The time/date may be reset
at each individual pager, or the time/date can be reset on all pagers simultaneously from the transmitter.
Set and Send Time/Date to all Staff Pagers: Be sure that all battery-powered pagers are on.
1. Press SETUP.
2. Press F1 (MORE) until display shows 1:Set Time/Date.
3. Press 1 (1: Set Time/Date.)
4. Press F1 (SET) to set time/date.
5. Enter Time (- -: - -) (e.g. 08:30) and press ENTER.
6. Press F1 (AM) or F4 (PM).
7. Enter Date (MM/DD/YY) (e.g. Mar 11, 2008 = 03/11/08) and press ENTER.
8. Press 1 (1: Send to Pager) to send time/date information to all staff pagers.
Long Range Systems 18 T7400 User Manual
To Next Page
Loading...
