Long Range Systems T9560 EZ - Paging Procedures; Paging Individual Pagers (1-799); All Page Function; Pager Message and Mode Settings

Long Range Systems 3 T9560 EZ User Manual
To turn on LRS Guest, press PROG-9-9-6-Enter
To turn on Alphanumeric (POCSAG) Staff, press PROG-9-9-7-Enter
To turn on SP4 Staff, press PROG-9-9-9-Enter
Paging Your Pager
The T9560 will page single pagers numbered from 1-799.
To page a pager from 1-20, simply press the pager number on the keypad.
Example:
To page pager #12, press 12.
To page a pager number from 21 to 799, press the PGR button, followed
by the pager number.
Example:
To page pager #22, press PGR-2-2-Enter, or PGR-2-2 (this will
send page, but with a delay)
To use the All Page, press PGR-9-1-1.
This will immediately send a page to all pagers.
Page Modes and Pager Messages
The T9560 uses a preset message and paging mode when paging or send-
ing a message to a pager.
To change the message, press PROG-8-x-x-ENTER (with x x being the mes-
sage slot from 00 to 99)
Note:
This command only applies to Alphanumeric Pagers
The Alphanumeric Staff message can be edited and changed to a user de-
fined set of messages.
(Please refer to LRS Programmer instructions for
changing messages.)
The pager vibration/beep mode can be changed based on the following se-
lections:
Example:
To change POCSAG Pagers to Vibe Twice, press PROG-9-5-2-
Enter. 9-5-0 - No vibration message.