Long Range Systems T9560 EZ - Pager Mode Specifics; Alphanumeric (POCSAG) Pager Modes; LRS Guest Pager Modes; SP4 Staff Pager Modes

Long Range Systems 4 T9560 EZ User Manual
Alphanumeric (POCSAG) Pager
950 – Vibe 1 time (send message)
951 – Vibe 2 times (send message)
952 – Vibe 3 times (send message)
953 – Vibe/Beep 1 time (send message)
954 – Vibe/Beep 2 times (send message)
955 – Vibe/Beep 3 times (send message)
LRS Guest
980 – Flash/Vibe 1 sec
981 – Flash/Vibe 30 sec
982 – Flash/Vibe 5 minutes
983 – Flash/Beep/Vibe 5 minutes
SP4 Staff
970 – Vibe 1 time (send message 1)
971 – Vibe 2 times (send message 2)
972 – Vibe 3 times (send message 3)
973 – Vibe/Beep 1 time (send message 1)
974 – Vibe/Beep 2 times (send message 2)
975 – Vibe/Beep 3 times (send message 3
Page Modes and Pager Messages
The T9560 can program any LRS Pager type. The transmitter’s current mode
of operation must match the desired pager type to program. (
Example:
To
program an SP4, the transmitter must be set to the SP4 Staff Mode.)
To program an SP4, coaster, or paddle pager:
1) Remove the pager from the charging base
2) Allow the pager to complete the vibration and flashing sequence
3) Press PROG then a number from 1-799 and press Enter
(
Example:
For Pager #200, press PROG-2-0-0-Enter)
4) The red LED in the top right corner of the transmitter will light up once
5) The pager will glow once cycle to indicate it received the programming