Long Range Systems 5 T9560 EZ User Manual
To program an Alpha Pager:
1) Remove the battery from the pager
2) Re-insert the battery into the pager
3) On the keypad, press a number from 1-799 and press PROG.
(
Example:
For Pager #200, press 2-0-0-PROG)
4) The red LED on the top right corner of the transmitter will light
up three times
5) The pager will then beep three times to indicate it received the
programming
Group Paging and Programming
The T9560 has the ability to program groups into the LRS Alphanumeric
Staff only. Up to 5 groups can be programmed into the transmitter and
pager.
Please note that when the Groups Setting is enabled, Groups are numbered
1-9, and paged using 001 through 009.
Any Alphanumeric Staff Pager with a programmed pager number 1-9
matching a specific defined group number, will be programmed higher than
100 for that pager’s number.
Example:
If Group 1 is defined and a pager is programmed as Pager #1,
the pager will display Pager #101 for the individual pager number and 1 for
Group Number.
To turn
ON
Group Paging, press PROG-9-9-1-Enter.
To turn
OFF
Group Paging, press PROG-9-9-0-Enter.
When Group Paging is enabled, select up to 5 Group Numbers to set and
define in the transmitter. Please follow these steps to setup Groups:
1) Turn
ON
Group Paging, press PROG-9-9-1-Enter
2) To set Group Number, press PROG-0-0-#-Enter (# is a number
from 1 to 9)
3) Program each individual pager that will belong to this Group
(see Pager Programming section)
To Next Page
Loading...