www.longer3d.com info@longer3d.com
8
requires 12v 5 Amps;
• When using an alternative Power Adapter, the
Voltage should always be 12v, the minimum
Amperage output should be 5 Amps. Higher amperage
output Power Adapter can be used without risk of damage
to your RAY5;
• On inserting the power barrel into your Motherboard it is
possible that a small spark is visible. This is NOT
hazardous to your machine and is caused by the 12v
power inrush. If you prefer to avoid this, connect the power
barrel to your motherboard first, then connect your power
adapter to the mains electricity plug;
• Once the RAY5 detects 12v present you will see the
motherboard emit a light red glow on the LED of the
Motherboard. This mean the your motherboard is powered.
• If when plugging your Power Adapter barrel to your
Motherboard and the Power adapter to mains power a Blue
LED does not turn on, please verify your power adapter is
receiving Mains Power.
To Next Page
Loading...
