www.longer3d.com info@longer3d.com
30
Question 4: What should I do if I cannot resume printing after
power shutdown?
3. Because the end of the
consumables in the nozzle will be
deformed by heat, if the end
deformed consumables are
directly pulled out, it may be
stuck to the pneumatic joint or
the limit switch for damage
detection. (The limit switch for
the broken material detection is
single. Towards).
If the power is suddenly turned off when the part is first printed, the
machine will not save the print data. Unless the height of the print
exceeds 0.5mm, the power failure will be supported. If the height is
less than 0.5mm, it is recommended to reprint directly.
To Next Page
Loading...
