www.longer3d.com info@longer3d.com
28
Question 2:What if the filament does not discharge from
the machine?
1. After the machine nozzle is heated, the
consumables are normally fed into the feeding
mechanism by hand, and then passed through
the Teflon tube to enter the nozzle.
2. When it is found that the gear of the feeding
mechanism emits a "beep" sound, it can first
check whether the consumables are wound,
causing the extrusion mechanism to pull the
material.
3 If this is not the reason, raise the machine
nozzle and use the 0.4mm needle in the
toolbox to insert it from below the copper
nozzle and rotate while inserting.
4. Under normal circumstances, this needle
can be used to open the copper nozzle, so that
the feed is smooth. The reason for this
blocking is generally that there are impurities
in the consumables, which leads to plugging.
To Next Page
Loading...
