www.longer3d.com info@longer3d.com
26
C. Installation and use of Cura 4.8 slicing software
(1) Software installation
The 3D printer reads Gcode files and prints. It is necessary to convert
3D files (such as STL files) into Gcode files for the machine to
recognize. Software that converts the 3D file into Gcode files is called
slicing software.
The video in the link below takes the installation of Cura4.8 on Mac
OS and Windows as an example to demonstrate the process of
software installation, adding models, and slicing the model.
Mac OS: https://www.youtube.com/watch?v=XKqRb434USw&t=96s
Windows: https://www.youtube.com/watch?v=jdLYBYFEBlQ&t=46s
To Next Page
Loading...
