LONGER RAY5 - Fire Extinguisher and Material Safety

www.longer3d.com info@longer3d.com
5
It is strongly recommended that a Fire Extinguisher should be
located within
close proximity to the RAY5. Extinguishers should be halogen or
multi-purpose dry chemical. Alternatively or in conjunction with the
Fire Extinguisher it is recommended a “Fire Extinguisher Ball” is
positioned beside the RAY5.
• DO NOT use materials that are highly flammable, explosive or
produce toxic
by-products;
• DO NOT remove material from the cutting bed before it has
cooled;
• DO NOT leave the RAY5 operating unattended;
• ALWAYS clean up clutter, debris and flammable materials in
the laser RAY5 bed after use;
• ALWAYS keep a properly maintained fire extinguisher nearby;
• DO NOT allow the USB cable to come in contact with the laser
Beam;
• DO NOT allow the 12v power cable to come in contact with
the laser Beam;