160/200/160P/200P AC/DC Series Machine
www.longevity-inc.com
Connecting the air regulator if one is not built inside the machine:
Hookup your air compressor to the inlet and the outlet to the GAS in on your unit. The water separator can
release water once you press the valve inside. Any compressor from 3 gallons and up is suitable as long as it has
4.0 CFM and puts out 90PSI. The unit must be switched to the PLASMA position on the front. Remember that
you want to set up about 65-75 PSI depending on what you are cutting. If your ARC fades, turn the PSI down.
To Next Page
