What causes arc or short circuit between contact tip and gas nozzle in LORCH M 2060?
An arc or short circuit between the contact tip and gas nozzle in your LORCH Welding System can be caused by spatter build-up inside the gas nozzle. Remove it with special pliers.
What causes higher wire wear out at wire-feeding unit of LORCH Welding System?
Higher wire wear out at the wire-feeding unit of your LORCH Welding System can occur if the wire rolls do not fit the wire diameter. Install the correct wire rolls. It can also be caused by incorrect contact pressure at wire feeding; adjust as described in the manual.
What to do if there is not sufficient shielded gas in my LORCH Welding System?
If there is not sufficient shielded gas in your LORCH Welding System, it could be due to: * Wrong adjusted quantity of shielded gas: Adjust it correctly as described in the manual. * Dirty pressure reducer: Check the valve. * Torch, gas hose blocked or not airtight: Check and replace if necessary. * Shielded gas being blown away by draught: Avoid draught.
What to do if mains control lamp 40 does not light on LORCH M 2060?
If the mains control lamp 40 does not light on your LORCH Welding System, it means that a phase is missing in the mains. Check the machine at another socket and check mains and fuses.
What to do if the fan of my LORCH Welding System is not working?
If the fan of your LORCH Welding System is not functioning, it indicates a missing phase in the mains. Check the machine at another socket and check the mains and fuses.
Covers fire prevention, flammable materials, and protection from arc rays during welding.
Addresses stopping operation at defects, mains cable safety, extinguishers, grounding, and electrical risk areas.
Details safe handling of gas cylinders and precautions during equipment transport.
Outlines safe methods and restrictions for transporting the welding equipment.
Covers electronic protection, stepswitch use, workpiece connection, and nozzle cleaning.
Covers EMC compliance, potential disturbances, and user obligations for proper operation.
Covers connecting torch, mains, wire spool, electrode, and ground connection.
Details connecting the gas cylinder, pressure reducer, and hose, and setting the flow rate.
Explains necessary changes to wire rolls, torch, and liner for aluminum welding.
Covers operating panel, power selection, welding modes, and adjustment controls for starting.
Explains the fundamental MIG/MAG welding process involving wire feed and shielding gas.
Details characteristics of short circuit, transitional, long, and spray arcs.
Presents working ranges for MAG welding based on wire diameter and arc type.
Describes the MSG-soldering process, similar to welding but without fusing base material.
Guidance on torch positioning and movement for various welding positions.
Explains how arc length affects penetration and weld bead characteristics.
Describes the impact of electrode stick-out on amperage and penetration.
Instructions for regular checks of plugs, cables, torch, and ground connection.
Details variations in feed units suitable for steel and aluminium wire.
General| Brand | LORCH |
|---|---|
| Model | M 2060 |
| Category | Welding System |
| Language | English |
To Next Page