What causes arc or short circuit between contact tip and gas nozzle in LORCH Welding System?
An arc or short circuit between the contact tip and gas nozzle in your LORCH Welding System can be caused by spatter build-up inside the gas nozzle. Remove it with special pliers.
What causes higher wire wear out at wire-feeding unit of LORCH Welding System?
Higher wire wear out at the wire-feeding unit of your LORCH Welding System can occur if the wire rolls do not fit the wire diameter. Install the correct wire rolls. It can also be caused by incorrect contact pressure at wire feeding; adjust as described in the manual.
What to do if there is not sufficient shielded gas in my LORCH M 2090 Welding System?
If there is not sufficient shielded gas in your LORCH Welding System, it could be due to: * Wrong adjusted quantity of shielded gas: Adjust it correctly as described in the manual. * Dirty pressure reducer: Check the valve. * Torch, gas hose blocked or not airtight: Check and replace if necessary. * Shielded gas being blown away by draught: Avoid draught.
What to do if mains control lamp 40 does not light on LORCH M 2090 Welding System?
If the mains control lamp 40 does not light on your LORCH Welding System, it means that a phase is missing in the mains. Check the machine at another socket and check mains and fuses.
What to do if the fan of my LORCH M 2090 is not working?
If the fan of your LORCH Welding System is not functioning, it indicates a missing phase in the mains. Check the machine at another socket and check the mains and fuses.
Emphasizes safe use of welding machines, removal of flammable materials, and protection against arc rays.
Specifies safe transport procedures, including securing the unit and removing gas bottles.
Details general usage regulations, unit protection against overloading, and workpiece grounding.
States the sound level of the unit is below 70 db(A) under standard load.
Informs about EMC standards and potential disturbances to other devices.
Provides detailed specifications for various M-Series welding models.
Connect the torch plug into the central socket for operation.
Connect the welding unit to the mains socket as per technical data.
Insert the wire spool onto the wire coil pick-up correctly.
Insert the wire electrode through the torch and connection.
Connect the ground clamp to the workpiece securely.
Description of controls and indicators on the operating panel.
Select mains voltage and switch on the unit.
Select welding mode (2-Stroke, 4-Stroke, Spot).
Fine-tune welding voltage for material and electrode.
Fine-tune wire feed speed.
Adjust spot welding time.
Monitor unit overload via yellow control lamp.
Explanation of the MIG/MAG welding process using wire electrode and shielding gas.
Describes short circuit, transitional, long, and spray arcs.
Table showing working ranges for different wire diameters and arc types.
Guidance on holding and manipulating the torch in various welding positions.
Explains how arc length affects penetration and bead appearance.
Details the impact of electrode extension on amperage and penetration.
Diagnoses issues like torch overheating, no wire feed, and irregular wire feeding.
Addresses problems like machine switching off, no mains light, and no shielded gas.
Covers less welding performance, hot plug issues, and wire wear.
Details variations for steel and aluminium wire feed units.
Instructions for environmentally compatible recycling of electric tools.
Provides company contact details for service inquiries.
Declaration of conformity to relevant European standards.
General| Brand | LORCH |
|---|---|
| Model | M 2090 |
| Category | Welding System |
| Language | English |
To Next Page