Need help?Do you have a question about the LORCH MicorMIG 400 and is the answer not in the manual?
General| Input Voltage | 3 x 400 V |
|---|---|
| Welding Process | MIG/MAG, TIG, MMA |
| Protection Class | IP23 |
| No-load Voltage | 68 V |
| Output Current Range (MIG) | 25 - 400 A |
| Cooling | Gas-cooled |
| Power Supply | Three-phase |
| Output Current Range (TIG) | 10 A - 400 A |
| Wire Diameter (MIG) | 0.8 - 1.6 mm |
General safety instructions for using welding and cutting machines, emphasizing qualified personnel.
Compliance with IEC 60974-4 for in-service inspection and testing procedures.
Explanation of the inverter technology used in MicorMIG machines for welding process control.
Details on DRV03/DRV13, DRV05/DRV15, DRV07/DRV17 driver boards, including functions and LEDs.
Description and functions of the MAPRO04 main control logic board.
Description and functions of the DMR-RT3 wire feed motor control board.
How the machine monitors bus voltage and associated error codes like E02 and E33.
How the machine monitors output voltage and related error codes E06, E12, E18.
Monitoring and driving the wire feed motor, including motor identification.
Comprehensive list of error codes, their causes, and troubleshooting remarks.
To Next Page
