LORCH MX 350 EU User Manual

LORCH
LORCH SchweiBtechnik GmbH
Im Anwander 24 - 26
D-71549 Auenwald
Telephone: +49 (0) 71911503-0
Fax: +49 (0) 71911503-199
Website: www.lorch.biz
Email: info@lorch.biz
Operation Manual
MX 350 EU
909.1900.1-03

LORCH MX 350 EU Specifications

General

Brand	LORCH
Model	MX 350 EU
Category	Welding System
Language	English

Summary

LORCH MX 350 EU Operation Manual

Safety and Ambient Conditions

Safety Precautions

Essential safety guidelines for operating the welding machine.

General Regulations, Protections, and Transport

Before Start-up Procedures

Electrode Welding Setup

Connects electrode welding cable and prepares for electrode welding.

TIG Welding Setup

Guides connecting the TIG torch and inert gas cylinder.

MIG Welding Setup

Details connecting the wire feed case for MIG welding.

Machine Start-up and Operation

Control Panel Overview

Describes the functions of the control panel buttons and displays.

Electrode Welding Process Start-up

Steps to switch on and select the electrode welding mode.

TIG Welding Process Start-up

Steps to switch on and select the TIG welding mode.

MIG Welding Process Start-up

Steps to switch on and select MIG welding modes.

Calling Secondary Parameters

How to access and adjust secondary operating parameters.

Special Functions: Gouging and Resets

Messages and Troubleshooting

Status Messages

Error Messages

Details error codes, their causes, and possible remedies.

Welding Basics and Principles

MIG/MAG Welding Fundamentals

Technical Data

Machine Specifications and Ratings

Comprehensive technical specifications for TIG, Electrode, and MIG welding.

Maintenance, Disposal, Service, and Compliance

Maintenance and Repair

Guidelines for routine maintenance and repair procedures.