LORCH MX 350 EU - Machine Start-up and Operation; Control Panel Overview

LORCH
12 Start-up
51 ~--= ~~ :=;;---__,,
50 ~ ~======:=::-~
49 ~,......,...=: ~~f k ,
Start-up
38 39 40 41 42 43
~
46
+ -
45
Fig. 8: Control penel MX 350
30
The Fault LED ~ ights up continuously, and the 38
The Synergy LED light sup if the Synergy function
fault co de is displayed in the 7 segment display
is selected.
35.
39
The MIX LED lights up if MIG we lding oper at ing
31
The Remote control LED lights up when a remote
mode with mixed gas is
selected.
control
is connected.
40 The C0
2
LED lights up if MIG welding operating
Control knob 48 specifies the maximum value for
mode with
C0
2
is selected.
the
control range of the remote control. If 1 OOA
41
The TIG LED lights up if TIG operating mode is
has been set,
for example, 1 OA - 1 OOA can be
called up using the remote control.
selected.
Lights up when wire feed case (case type ln t) is
42 Electrode LED
connected
lights up if Electrode operating mode is selected.
32 LEDVRD
43 Electrode CEL LED
lights up continuously with active VRD function
lights up with operating mode Electrode CEL
(reduction in idle running voltage) flashes if the
sel
ec ted (Electrodes w ith cellulose-containing
output voltage exceeds the value pe rm itted by
encapsulation,
suitable for vertical downward
the standard (e.g. in welding mode or
if operating
welding)
mode MSG welding LED 39, 40 selected)
flashes
if gouging operating mode selected.
33
The Seconds LED lights up when a value is dis-
44 welding process selector switch
played in the 7 segment
display 35 in sec .
serves for
selecting the TIG operating mode,
34 The % LED lights up when a value is displayed in
MIG welding with mixing gas
the 7 segment display
35 in percent.
MIG welding with C0
2
•
MMA or CEL electrode.
35 7-Segment-Display
If you hold the button down f or longer than 2
indicates the
selected power level, we ld voltage
sees ., if the MIG (MIX/CO,) operating mode has
or wire feed speed.
been
selected, the Synergy operating mode is
If the secondary parameters are activated, the
switched
on (LED Syner gy 38 lights up).
code and the set
value are shown alternately.
If you hold the button down for longer than 2
36
Welding vo lta ge LED lights up when the welding sees., if the Electrode (MMA/CEL) oper at ing
voltage is
displayed in the 7 segment display 35 mode has been selected, the gouging opera!-
in volts.
ing mode is switched on (LED Electrode CEL 43
37
The Welding current LED li ghts up when the
flashes).
welding
current is displayed in the 7 segment 45 Polarity indication
display 35 in amps.
46
Polarity indication
-10 ·
10.13