LORD W1 - Result problems

47
Fault Cause Troubleshooting
Detergent dosage is too
high.
• Immediatemeasure:Mixonetable-
spoon of fabric softener with 0.5 litres
of water and pour the mixture into
the left-hand compartment (not for
outdoor clothing, sportswear or items
stued with down).
• Reducetheamountofdetergentforthe
next washing cycle with the same load.
Unapproved extension
installed on the water
drain hose.
• Removeanyunapprovedextensions
from the water hose. Connecting the
appliance.
Waterisnotowingin.
Detergent is not being
dispensed.
You have not pressed
Start - Pause.
• PressStart - Pause.
The lters in the water
inow are blocked.
• “Cleantheltersinthewaterin-ow”
The tap is turned o. • Turnonthetap.
The water inlet hose is
kinked or jammed.
• Ensurethatthewaterinlethoseisnot
kinked or jammed.
The spin cycle runs
several times.
The unbalanced load
detection system
eliminates an imbalance
by repeatedly
redistributing the
laundry.
• Notafault–noactionrequired.
Note:Whenloading,wherepossible,place
large and small items of laundry together
in the drum. Dierent sized items of
laundry distribute themselves better
during the spin cycle.
The programme
duration changes
during the wash cycle.
The programme
operation is optimised
electronically. This may
change the programme
duration.
• Notafault–noactionrequired.
The unbalanced load
detection system
eliminates an imbalance
by repeatedly
redistributing the
laundry.
• Notafault–noactionrequired.
Note:Whenloading,wherepossible,
place large and small items of laundry
together in the drum. Dierent sized items
of laundry distribute themselves better
during the spin cycle.
Foam detection system
switches on a rinse cycle
if foam build-up is too
high.
• Notafault–noactionrequired.
No water is visible in
the drum.
Waterisbelowthe
visible area.
• Notafault–noactionrequired.