Use "H" to connect the wire
to the top panel through "G".
Use "B" to connect the top panel.
Connect the frame to top panel by 16pcs "A" screws.
A
X 16
B
X 3
G
X 3
H
X 3
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to be sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packing straps before you start to assemble.
• Don’t tighten all screws/bolts until all completely assembled.
• Keep all hardware parts out of reach of children.
• It is recommended for 2 persons to complete this assembly.
Two people are required to
assemble and move this model.
STEP 7
STEP 8
COMPLETED ASSEMBLY
Assembly Instructions
60" Pneumatic
Height Adjustable Desk
99551/59605/59606/59634/59635/59636/16202/59611/59612
Pull the lever to adjust the height up or down.
To lower height, pull the lever while pushing the
center of table top down to desired height.
Make sure the distances from
metal frame to all top panel edges
are distributed evenly.
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY.
SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!
G
H
A
B
( ≤ 33 lbs
≤15kg)
To Next Page
Loading...
Need help?
General
