8
Installing the camera
Basic Setup
Installing the antenna
Twist the antenna clockwise onto the receiver’s antenna jack.
NOTE: You can also connect an accessory antenna to increase the receiver range. For
det
ails, see “Appendix D: Strengthening the Range of the Wireless Signal” on
page 34.
Connect antenna to receiver
Turning on the receiver
To turn on the receiver:
1 Connect the cable from the power adapter to the 5V DC port on the bottom panel of the
r
eceiver. Plug in the power adapter to an outlet or surge protector.
2 OPTIONAL: To view the receiver on a television, connect the included AV cable to the AV OUT
port on the system. Connect the other end of the cable to the television. For details, see
“Viewing A/V Output” on page 62.
3 Slide
the power switch on the rear panel to the "ON" position
.
Tip:
• Place the receiver in a location that will have a clear reception to your camera. Rotate the
ta
bletop stand to help position the LCD receiver to your liking.
• Adjust the antenna on the receiver as necessary to provide the clearest reception.
To Next Page
Loading...
Need help?
General
