INSTRUCTION MANUAL
CAL. Y182 (RSZ SERIES)
NREY182
08-96
■ CHARACTERISTICS
1. Time: Indicated by the hour, minute and
small second hands.
2. Date: Displayed in numerals.
3. Alarm: Set on a 12-hour basis with two
small hands displaying the designated alarm
time.
4. Stopwatch: Measures up to 30 minutes
in 1/5 second increments.
•Split time measurement
5. Battery life indicator: The small second
hand moves at two-second intervals when
the battery needs to be replaced.
■ DISPLAY AND CROWN OPERATION
Minute hand
Stopwatch
minute hand
Alarm minute handAlarm hour hand
Crown 1
a. Normal position: Free
b. First click : Setting the date by turning
Crown 1 clockwise
c. Second click : •Setting the time
•Adjusting the stopwatch
hand position
Crown 2
a. Normal position: Free
b. First click : Alarm engagement
c. Second click : Setting the alarm hands
to the current time
■ HOW TO SET THE DATE
B
C
A
Hour hand
Small
second
hand
a b c
Crown 1
a b c
Crown 2
Stopwatch
1/5-second hand
Date
Minute handHour hand
Crown 1
Date
Second click
First click
1. Pull out Crown 1 to the first click.
2. Turn Crown 1 clockwise until the previous
day’s date appears.
3. Pull out Crown 1 to the second click, and
advance the hour and minute hands until
the desired date appears.
4. Push Crown 1 back into the normal position.
Note:
Do not set the date between 9:00 p.m. and
1:00 a.m. Otherwise, the date may not change
properly.
* If it is necessary to set the date during that time
period, first change the time to any time outside
it, set the date and then reset the correct time.
■ HOW TO SET THE TIME
Small
second
hand
Minute handHour hand
First click
Crown 1
Second
click
1. Pull out Crown 1 to the second click when
the small second hand is at the 12 o’clock
position. The small second hand stops on
the spot.
2. Turn Crown 1 to set the hour and minute
hands to the desired time.
3. Push Crown 1 back in to the normal position
in accordance with a time signal.
Notes:
1. When setting the hour hand, be sure to
check that AM/PM is correctly set. The
watch is so designed that the date changes
once in 24 hours.
2. When setting the minute hand, first advance
it 4 to 5 minutes ahead of the desired
time and then turn it back to the exact
minute.
■ HOW TO USE THE ALARM
• The alarm time is set on a 12-hour basis.
• The alarm hands move independently of
the center hands.
Adjustment of alarm hands
Before setting the alarm, first set the alarm
hands to the current time indicated by the
center hands.
Minute handHour hand
Alarm
minute hand
1. Pull out Crown 2 to the second click.
A beep sounds for one second.
2. Turn Crown 2 to set the alarm hands to
the time indicated by the center hour and
minute hands.
3. Push Crown 2 back in to the normal position.
Note:
When setting the alarm minute hand, first
advance it 4 to 5 minutes ahead of the current
time and then turn it back to the exact minute.
Crown 2
Second click
Alarm
hour hand
To Next Page
Need help?
General
