Make the connections to the front posts in the
same way you did the connection to the castle
section.
Fasten all eight cap nuts, using the wrench
number 10.
Cut the ties that hold the lams to the back rail.
Position the lams, one by one, with their ends
into the nylon bearings, starting with the rear
lam.
Insert one end of the lam into the bearing,
while holding the other end of the lam just
underneath the side rail. Now bring that other
end to its bearing by bending the lam slightly.
Push the end into the bearing while you move
the lam up and down.
To Next Page
Loading...
