Louet David - Hardware Bag 2 Contents

7
Open hardware bag 2
The hardware bag contains:
− 6 axle support blocks
− 6 screws 6 X 70
− 5 axles  6 X 122 mm
− 5 nylon bushings  6-8 X 30
− 4 screws5 X 50
− 80 screws 4 X 17
Screw the small screws into the eight holes of
each treadle, so far that the screw heads
protrude approximately 5 mm (3/16”) from the
wood. The thread of the screws should just
disappear into the wood.
Assemble the treadles onto the foot rail. The
screw heads on the treadles should point
towards the middle so that the five treadles on
the left side are opposite to the five treadles at
the right side.
Slide two treadles with a nylon bushing in
between on each axle. Use the axle
suspension blocks and the big screws to
assemble these pairs of treadles to the foot
rail.