Loup Electronics Weighlog 100 User Guide And Installation Manual

Reference/Direction Sensor
Page 12
Reference/Direction Sensor Mounting
Magnet mounting
Mark the hole positions drill and tap 2 holes M6 in the lift arm for the magnet
bracket. In some cases the magnet can be mounted directly onto the lift arm
but you must install the fiber washer between the magnet an the lift arm.
Install the bracket and attach the magnet using the stainless steel screw and
the fiber washer between the magnet and bracket.
Do not drill the lift arm above the centerline of the lift arm!
Ref/Dir Sensor Connection
Connect the extension cable to the
Weatherpack connector on the sensor
lead, route the cable back to the
junction box. Secure the cable with
wire ties to avoid damage to the cable.
Connect the wire according to the label
on the Junction Box lid.
Color Function Terminal #
Blue Common 6
Green
Red Ref. Sig. 7
Yellow Dir. Sig. 4
12
11
10
9
8
7
6
5
4
3
2
1

Loup Electronics Weighlog 100 Specifications

General

Brand	Loup Electronics
Model	Weighlog 100
Category	Accessories
Language	English