Loupedeck Loupedeck+ - Page 11

Copyright (c) 2017 Loupedeck Ltd. All rights reserved.
11
Scroll 3
(yellow)
Scroll 4
(green)
Scroll 5
(aqua)
Turn Scroll 2 in either direction to toggle through blending
modes. Press Scroll 2 to reset Blending Mode.
Turn Scroll 3 upwards to increase tool opacity. Turn Scroll 3
downwards to decrease tool opacity.
Press Scroll 3 to reset opacity to 100%.
Turn Scroll 4 upwards to increase tool Flow.
Turn Scroll 4 downwards to decrease tool Flow.
If Flow is not available, then Scroll 4 will adjust an attribute
that is comparable to Flow (e.g. Strength, Exposure).
Press Scroll 4 to reset flow to 100%.
Turn Scroll 5 upwards to increase tool smoothing. Turn
Scroll 5 downwards to decrease tool smoothing.
Press Scroll 5 to reset smoothing to 0%.
Brush attributes can be set with greater detail when Custom Mode is enabled. Through factory
default Brush attributes are set to the partial tone adjustment dial group.
FUNCTIONS
CUSTOM MODE DIAL
WHAT CAN YOU DO WITH IT?
Brush
attributes
Custom Mode,
Blacks,
Whites,
Shadows,
Highlights,
FN
When Custom Mode is enabled all necessary brush controls
are assigned to a group of basic dials.
Rotate Blacks to set brush size.
Press Blacks to set brush size to 25.
Rotate Whites to set brush opacity
Press Whites to reset opacity to 100%.
Rotate Shadows to set brush flow.
Press Shadow to reset flow to 100%.
Rotate Highlights to set brush smoothening.
Press Highlights to reset smoothening to 0%.
Rotate FN+Blacks to set brush hardness.
Press FN+Blacks to reset brush hardness to 0%.