Code: MSGB202$0500.doc 18/06/2004 P. 16 / 20
Once the window illustrated has been opened, from the pull-down box choose the name of the installation
with which you want to be connected. The names entered in the Modem index during configuration will be
displayed. Once the choice has been made, the corresponding phone number appears in the box below.
Click the Dial button to start the connection procedure.
At this point the program will instruct the modem to make the call. While waiting, the sliding blue bar of the
maximum time allowed for making the connection will be seen (1 minute). The modem called will take the
line and exchange the usual handshaking messages with the answering modem. At the end of this
procedure, if everything has been carried out correctly, the PC status bar will show a message informing the
user that connection has taken place and the program will switch automatically to the Online mode. If any
errors occur, carefully check the connections and if necessary follow the Troubleshooting guide given in
appendix A of this manual. Normally connection is not critical since very common and absolutely standard
procedures are used. With the Break button it is possible to block the calling procedure, while Hang up ends
a communication already in progress.
Hang up
This command interrupts a modem connection, closing the telephone line. It is the equivalent of hanging up
the handset in an ordinary phone call. It is carried out automatically every time you exit the program.
To Next Page
Loading...