Doc:MSGB102A0205.doc 15/07/11 P. 2/20
Introduction
With ATLSW Remote control software, you can connect one or several ATL transfer switches to a PC via a
RS232 serial port or a RS485 serial bus.
It can be used for commissioning of the controller, for troubleshooting in case of problems and also for
continuous supervision.
The software provides the following functions:
• Graphic display of all the measurements returned by the device
• Access to the Setup menus
• Access to ATL Real time clock
• Access to ATL statistic data
• Possibility of set-up parameter save/load/printout
• Display of virtual front panel of the controller with the possibility of activating the keys
• Switching between operation modes
• Keypad lock function
• Display of the Event log, showing the most recent 100 events with date and time
Minimum resources of the PC
• Windows
®
95/98/2000/XP/Vista/7 operating system
• Graphic card with 1024x768 or higher resolution
• A free standard RS232 serial interface (COM:)
• 64Mb of RAM
• Pentium
®
class or higher processor
• CD-ROM drive for installation
Installation
To install the software, you need a PC with the operating system already installed and running and the
program setup CD. You should also have at least a basic knowledge of the PC and be familiar with
Windows
®
. operating system commands.
1. Close all applications running
2. Insert the CD in the drive
3. From the root directory, start the atl_setup_###.exe program
4. If a previous installation is already present on the hard drive, then the installation program will
automatically start a procedure to remove the older revision. After this , the installation process will start.
5. A window is displayed asking you to specify the directory in which you want to install the program. To
change directory, enter the new name in the specific box.
6. Follow the instructions that will be shown until the end of installation.
7. Reboot the PC.
To Next Page
Loading...
