Doc:MSGB102A0205.doc 15/07/11 P. 4/20
Main window
The main window displays all the various measurements returned by the device, providing a complete
overview of the panel status.
All the functions are accessible from the drop-down menus and those used most frequently are also shown
on the toolbar. Some of these functions are blocked and can be accessed only after entering the user-
modifiable password (at the first setting, the default password is LOVATO).
The following are displayed in the main window:
• Voltage and frequency of both Line 1 and Line 2 sources
• Switching devices status
• ATL supply status
• Alarm status
Lastly, the following are indicated, from left to right, on the status bar close to the lower edge of the main
window:
• Model and release of the internal firmware of the ATL connected
• Serial communication status (ONLINE = connection active, OFFLINE = connection not active)
• ATL operating mode
• Any alarm conditions
• Page refresh rate
• Modem connection status (if used)
To Next Page
Loading...
