Why is my LoveGo G2 Medical Equipment alarm beeping with solid green and red lights?
If your LoveGo Medical Equipment alarm beeps and the green and red lights are solid, it means the concentrator temperature is too high, and oxygen production is shutting down. Make sure the bottom outlet vents are not blocked. If the problem continues, use a backup oxygen source and contact your equipment provider.
How to turn on LoveGo Medical Equipment if it doesn't power on?
If your LoveGo Medical Equipment is not powering on when you press the On/Off button, make sure the power switch at the bottom is turned on.
What to do if there is no oxygen from my LoveGo Medical Equipment?
If there is no oxygen coming from your LoveGo Medical Equipment, check the cannula and its connection to the concentrator nozzle to ensure it is properly connected and not kinked or blocked.
What to do if LoveGo G2 Medical Equipment alarm is beeping but the LCD display doesn’t light on?
If the alarm on your LoveGo Medical Equipment is beeping and the LCD display isn’t lighting up, the AC power supply might not be connected correctly. Verify the power supply connection.
What to do if LoveGo Medical Equipment battery runs off?
If your LoveGo Medical Equipment battery runs out, you should recharge the battery or use a spare battery.
What does it mean if the yellow light is solid on my LoveGo Medical Equipment?
If the yellow light on your LoveGo Medical Equipment is solid, it means the concentrator is producing oxygen at a low level (less than 82%). Contact your equipment provider.
What to do if the red light is solid for more than 5 minutes on LoveGo Medical Equipment?
If the red light on your LoveGo Medical Equipment stays solid for more than 5 minutes, it means the concentrator is producing oxygen at a low level (less than 72%). Contact your equipment provider.
Check rating, keep cords from heat, do not operate if damaged or wet.
Avoid smoking/flames near unit, no oil/grease due to oxygen promoting rapid burning.
Reduce risk of serious or fatal injury from electrical shock.
Check electric rating, keep cords from heat, do not operate if damaged.
Device produces oxygen, avoid smoking/flames, no oil/grease near unit.
Do not leave headset under cover when unit is on; oxygen makes material flammable.
Turn off unit and remove power cord before maintenance.
Address yellow (low purity <82%) or red (low purity <75%) lights and alarms.
General| Device Type | Portable Oxygen Concentrator |
|---|---|
| Oxygen Concentration | 93%±3% |
| Oxygen Output/Flow Rate | 1-5 L/min |
| Oxygen Purity | 93%±3% |
| Sound Level | ≤ 45 dB(A) |
| Battery Charging Time | 4-6 hours |
| Power Consumption | 90 W |
| Noise Level | ≤ 45 dB(A) |
| Power Supply | AC 220V, 50Hz |
| Operating Temperature | 5°C to 40°C |
| Alarms | Low oxygen concentration alarm |
To Next Page
