Lovi Prolactis - Page 10

8
Make sure the tubing connector is properly inserted
into the electric pump base.
Do not remove the lm. Lift tab to insert the tubing
adaptor. Pull the tab down to cover the inlet after
use to keep the motor dust free.
Press the On/O button
to begin pumping.
Adjust the suction in the stimulation cycle to your comfort level while
pumping by rolling the vacuum adjusting wheel
up (+) or down (-).
Hold the expression collection combo kit to your breast so that your nipple(s) are
centered inside the breast shield.
IMPORTANT NOTE! Make sure that funnel or silicone cushion (if you use it) clings
tightly to the breast, otherwise the suction strength may be reduced.
If you want to increase the suction strength, use the funnel without the silicone cushion.
The LCD screen shows the time of your last pumping session for a few seconds,
the pump will automatically begin in the stimulation cycle.
On/O
vacuum adjusting wheel
let-down button
If you prefer to bypass the pre-set stimulation cycle
or your milk lets down sooner
than 2 minutes, press the let-down button
to switch to the expression cycle.
On/O