Lovi Prolactis - PUMPING INSTRUCTIONS; Before each use; Using 4 AA Alkaline batteries

GB
7
Open the battery cover.
Insert 4 new AA alkaline batteries.
Note: Make sure the polarity is correct as indicated.
Remove the old batteries
if you are replacing them.
Close the battery cover, making
sure it „snaps” into place.
Using 4 AA Alkaline batteries (1,5 V)
WARNING!
• Always replace all 4 batteries at the same time.
• Remove all batteries from the electric pump base if the Electric Breast Pump is not going
to be used for extended periods of time.
• Properly dispose of all batteries, according to regulations for environmental protection
and recycling.
• Alkaline batteries may present a risk of re or chemical burn if mistreated. Do NOT
disassemble any battery. Do NOT place batteries near heat source or re. Dispose of used
batteries properly. Do NOT dispose of batteries in re. Keep away from children.
PUMPING INSTRUCTIONS
Before each use:
• Wash your hands thoroughly before using the pump.
• Ensure that the pump is pre-washed and dried, if not, follow the instructions located below.
• Ensure that there is no liquid or moisture in the silicone tube. Never operate the pump if you notice
any water in the silicone tube.
Note! Do not mouth blow the silicone tube in order to remove water.
tubing
connector
Take the white end of vacuum tube and connect to the tubing
connector located on the cap. Push together rmly for a tight seal.
Note! Ensure that there is no liquid or moisture in the silicone tube.
GB