GB
9
When your pumping session is nished,
turn the pump o by pressing
the On/O button.
After the pump has been turned o, the display will remain on for
a few seconds. The display will show the total amount of pumping
time, then automatically switch to standby/clock mode, or alarm
clock mode if the alarm was turned on.
Note: Make sure there is no suction on the nipple(s) before removing the breast shield.
If necessary, break the suction by inserting a nger between the breast shield and the
breast, similar to the way you break away from your baby’s suction.
Note: If the Electric Breast Pump Prolactis is left on, but unattended for more
than 30 minutes, the pump will automatically shut-o.
Adjust the suction in the expression cycle to the most
comfortable and eective level while pumping by rolling
the vacuum adjusting wheel
up (+) or down (-).
After two minutes, the stimulation cycle will end
and automatically switch to the expression cycle.
The expression icon
will appear and indicate
that you are in the expression cycle.
expression cycle
stimulation cycle
vacuum adjusting wheel
On/O
GB
To Next Page
Loading...
