| 27
Radio menus | Link-9 User Guide
DSC setup
DSC function
It’s recommended DSC functionality is always enabled, unless
operating the vessel in an ATIS region. An MMSI number must be
entered in radio before the DSC function can be enabled. When
enabled, the
symbol is displayed.
User MMSI
Enter an MMSI number to access the radio’s DSC functionality. This
unique identifier must be supplied a local radio spectrum authority.
DO NOT enter a random ‘made up’ number.
¼ Note: Contact a Lowrance dealer if you need to change your MMSI
after initial input.
ATIS function (EU ATIS radios only)
ATIS must be enabled when navigating inland waterways in
signatory countries of the RAINWAT agreement. It should NOT be
used outside these regions. DSC functionality is not possible when
ATIS is turned on. When enabled, the symbol is displayed.
Sea/Inland use (EU ATIS radios only)
Toggles between DSC (Sea) and ATIS (Inland) modes. Does not allow
both to be selected at the same time.
ATIS ID (EU ATIS radios only)
Enter an ATIS number to access the radio’s ATIS functionality. This
unique identifier must be supplied a local radio spectrum authority.
DO NOT enter a random ‘made up’ number.
¼ Note: Contact a Lowrance dealer if you need to change your ATIS ID
after initial input.
Individual acknowledge
The radio can be configured to automatically acknowledge an
incoming ‘individual’ call, or require manual intervention:
Auto
After a 15 second delay, radio will switch to requested channel, and
send an automatic acknowledgement, ready for conversation.
US country mode default.
To Next Page
Loading...
