Chapter 5. Loader
5.3 Moving to other groups
There are two different parameter groups in SV-iE5 series as shown below.
Moving to the other parameter group
PG groupDrive group
SHFT
SHFT
SHFT SHFT
Can move between groups if pressing SHFT key in code 0 of Drive Group/PG
Group as shown in the figure. If pressing SHFT in other codes but 0, it moves to
the first code of a selected group and it moves between groups if pressing SHFT
once more.
1)
Target frequency is set in the first code of Drive Group. It is delivered with 0.00
set as the default and any differently changed driving
frequency is displayed once
a user changes it.
Type Description
Drive group Basic parameters
necessary to operate the
inverter; target frequency,
acceleration/deceleration
time and etc.
PG group Parameter group for
additional functions
PG group
Drive group
To Next Page
Loading...
