LS Industrial Systems SV-iE5 Series - User Manual

Instructions
i
Thank you for purchasing LS Variable Frequency Drives!
Safety instructions are prepared to use the product safely and correctly by
preventing any accident or risk beforehand, so they should be always kept.
 In this manual, safety instructions are divided into two classes; each has the
following meaning.
WARNING Improper operation may result in serious personal injury or
death.
CAUTION Improper operation may result in slight to medium personal
injury or property damage.
 Throughout this manual, we use the following two illustrations to make you
aware of safety considerations.
identifies potential hazards under certain conditions.
identifies shock hazards under certain conditions.
 After reading this manual, keep it handy for any user to quickly refer to.
 Read this manual carefully to user SV-iE5 Series Inverter’s functions
appropriately and safely.
 Do not remove the cover while the power is applied or the unit is in operation.
Or, it may cause electric shock.
 Do not run the inverter with the front cover removed.
Or, it may cause an electric shock due to high voltage terminals or charged
capacitor exposure.
 Do not remove the cover except for periodic inspections or wiring, even if the
input power is not applied.
Or, it may cause an electric shock due to charged capacitor exposure even if
the power is cut off.
 Wiring and periodic inspections should be performed at least 10 minutes after
disconnecting the input power and after checking the DC link voltage is
discharged with a meter(below DC 30V).
Or, it may cause an electric shock (below DC 30V)
 Operate the switches with dry hands.
Or, it may cause an electric shock.
Warning
SAFETY INSTRUCTIONS

LS Industrial Systems SV-iE5 Series Specifications

General

Cooling Method	Fan cooling
Enclosure Rating	IP20
Output Frequency	0.1~400Hz
Overload Capacity	150% for 60 seconds
Control Method	V/F control
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit
Communication	RS485 (Modbus RTU)
Storage Temperature	-20°C to +65°C
Humidity	5~95%RH (Non-condensing)
Altitude	Below 1, 000m
Braking Unit	Built-in braking transistor (External braking resistor required)