Instructions
Do not use the cable when its insulating tube is damaged.
Or, it may cause an electric shock.
Do not subject the cables to any heavy load stressful to them.
Or, it may cause an electric shock due to damaged cable.
Install the inverter on a non-flammable surface.
Or, it may cause a fire if being installed on or closely to a flammable material.
Disconnect the input power if the inverter gets damaged.
Or, it may result in a secondary accident and fire.
After the input power is applied or removed, the inverter will remain hot for a
couple of minutes.
Otherwise, you get bodily injuries such as skin-burn or damage.
Do not apply power to a damaged inverter or an inverter with parts missing
even if the installation is complete.
Or, it may cause an electric shock.
Do not allow screw, metal chips, water drops, oil or other impurities into the
inverter.
Or, it may cause a fire.
(1) Transport and installation
Carry it correctly according to the specified weight.
Do not stack the inverter boxes higher than recommended.
Install according to instruction specified in this manual.
Do not open the cover during transport.
Do not place any heavy load on the inverter.
Check whether the inverter mounting direction is correct.
Do not drop the inverter, or subject it to impact.
Follow your national electrical code for grounding(200V).
As soon as detaching PCB(Printed Circuit Board) for installation or repair, make
sure to place it on conductor. Otherwise, it may cause destruction due to static
electricity.
Use the inverter under the following environmental conditions.
To Next Page
Loading...
Need help?
General
