LS Industrial Systems SV004iE5-1 - Page 25

Chapter 5. Loader
5-5
 Code jump
Moving from code 1(P 0) to the code15(P15) in PG Group
FUNC
SHFT
X5
FUNC
1
-. It displ
ays P0, the 1st code of
Drive Group.
-. Press FUNC key.
2
-. SET lamp lights up. Changeable
number blinks
-
. It shows moving to Code 1 is
possible. Set 5 using UP()
key.
3
-. The 1st digit is changed to 5.
-. Press SHFT key.
-. Blinking cursor moves and 05 is
displayed.
Change it to 1 using
UP() key.
4
-
. It shows moving to Code 15 is
possible.
-. Pressing FUNC key enters 15.
5
-. SET lamp is out.
-. It displays Code 15 of PG Group.
 Code change in PG Group
Moving from code 1 to code 15 in PG group
1
-. It displays Code 1 of PG Group.
-. Keep pressing UP() key until P
15 is displayed.
2 -. It displays Code 15 of PG Group.
Note
Some codes will be skipped in the middle of increment ()/decrement (
) for
code change in PG Group. That is because it is programmed that some codes
are intentionally reserved for later
use or the codes user does not use are
invisible.