4 -8
HST type
Position control lever
Range gear shift lever
HST reverse pedals
Brake pedals
Throttle lever
Parking brake lever
Cruise control lever
HST forward pedals
2. Set the engine speed more than 1500
rev/min.
3. Place the range gear shift lever on a
suitable position.
4. After pressing down brake pedals and
release the parking brake lever.
5. Press the HST forward/reverse pedal down
slowly to move the tractor.
6. If necessary, move the cruise control lever
downward to set the forward driving speed
constantly while driving forward.
1. Lift up all the implements (front/middle/rear)
from the ground after starting engine.
▶ If pressing the brake pedals or HST forward pedal deeper, the cruise control drive
will be stopped.
▶ For HST models, there is a switch on the driver’s seat to control the engine cut-off
system for driver’s safety. If you leave the driver’s seat without safety measures,
the engine will be stopped automatically. (For the details, see chapter 2-1-(2))
▶ When driving or working with a HST model, run the engine at 1500 rev/min or
higher to maintain the hydraulic system stable.
▶ Operate the HST forward/reverse pedal slowly to prevent a sudden start or stop.
Caution
To Next Page
Loading...
Need help?
General
