To Next Page

To Previous Page

CERTIFICATION NOTES 9

4.1 FCC and IC – Instructions to

the User

This equipment has been tested and found to

comply with the limits for a class B digital device,

pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio

frequency energy and if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However,

there is no guarantee that interference will not occur

in a particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try

to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

In order to maintain compliance with FCC

regulations, shielded cables must be used with

this equipment. Operation with non-approved

equipment or unshielded cables is likely to result in

interference to radio and TV reception.

FCC ID: QVBGS200 IC: 7076A-ICGS200

RF Exposure Warning:

This product complies with FCC/IC radiation

exposure limits set forth for an uncontrolled

environment. To comply with RF exposure

requirements, the unit must be installed and

operated with 20 cm (8 in.) or more between

the product and your body. This product may

not be collocated or operated in conjunction

with any other antenna or transmitter.

This device has been designed to operate

with the antennas listed below, and having

a maximum gain of 3.0 dB. Antennas not

included in this list or having a gain greater

than 3.0 dB are strictly prohibited for use with

this device. The required antenna impedance is

50 ohms.

To reduce potential radio interference to other

users, the antenna type and its gain should

be so chosen that the equivalent isotropically

radiated power (e.i.r.p.) is not more than that

permitted for successful communication.

Antenna List

LSI P/N: TA011

Description: 1/4 wave monopole

MFG Load Systems International

FCC ID: QVBGS000 IC: 7076A-ICGS000

FCC ID: QVBGS001 IC: 7076A-ICGS001

FCC ID: QVBGS050 IC: 7076A-ICGS050

FCC ID: QVBGS075 IC: 7076A-ICGS075