MESSAGE on the primary DSP display
■ MIMIC ITEM CHECK
It displays whether MIMIC picture data is there or not. If mimic data exist, it displays
“EXIST”. And if mimic data doesn’t exist, it displays “NONE”.
■ MIMIC MAP CHECK
It confirms whether MIMIC MAP data is there or not. MIMIC map means that mimic
block plan drawn by user. If mimic data exist, it displays “EXIST”. And if mimic data
doesn’t exist, it displays “NONE”.
■ INITIALIZE VARIABLE
It initializes various variables for operating device.
■ INIT RELAY VARIABLE
It loads the data of saved setting data. If this is the first operating, device sets all value
Max and uncheck all relay elements.
■ Calibration CRC : 1234
It displays CRC of calibration data. It is different from all devices. If this value has
error, device initializes by itself.
■ LOAD CALIBRATION DATA
If calibration CRC data is available, RAM loaded. If calibration CRC data is not
available, it displays “CALIBRATION DATA RESET TO 0”.
■ MAIN INITIALIZATION OK
MAIN MMI CPU reset is ok.
■ DSP INITIALIZATION
It displays whether DSP initialization is ok or not. If DSP initialization is not available, it
displays “NONE” and device can not operate.
1
11
1.
..
.
MMI
MMIMMI
MMI
To Next Page
